OBJECT              = COLUMN
    NAME              = "DEFAULT AMPLITUDE"
    COLUMN_NUMBER     = 1
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 1
    BYTES             = 4
    DESCRIPTION       = "Default amplitude in mV."
  END_OBJECT          = COLUMN

  OBJECT              = COLUMN
    NAME              = "DEFAULT PHASE"
    COLUMN_NUMBER     = 2
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 5
    BYTES             = 4
    DESCRIPTION       = "Default phase for tip (0-8).
                         For positive amplitudes,
                         degrees=20*phase. For negative
                         amplitudes, degrees=20*phase+180."
  END_OBJECT          = COLUMN

  OBJECT              = COLUMN
    NAME              = "X OFFSET"
    COLUMN_NUMBER     = 3
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 9
    BYTES             = 4
    DESCRIPTION       = "X offset for tip (steps)."
  END_OBJECT          = COLUMN

  OBJECT              = COLUMN
    NAME              = "CENTER FREQUENCY"
    COLUMN_NUMBER     = 4
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 13
    BYTES             = 4
    DESCRIPTION       = "The center frequency in Hz for tip."
  END_OBJECT          = COLUMN

  OBJECT              = COLUMN
    NAME              = "FREQUENCY"
    COLUMN_NUMBER     = 5
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 17
    BYTES             = 4
    DESCRIPTION       = "The frequency at which to start
                         the frequency test for tip."
  END_OBJECT          = COLUMN

  OBJECT              = COLUMN
    NAME              = "TIP STATE"
    COLUMN_NUMBER     = 6
    DATA_TYPE         = MSB_UNSIGNED_INTEGER
    START_BYTE        = 21
    BYTES             = 4
    DESCRIPTION       = "Tip state (0=NOT_TESTED, 1=DEAD,
                           2=NOT_CENTERED, 3=OUT_OF_RANGE,
                           4=NOISY, 5=OK). This value is
                           written by the software, and not
                           usefully initialized to anything
                           other than 0."
  END_OBJECT          = COLUMN